Worksaver GLB-330 User Manual download pdf (Page 21)

520

SAFETY INSTRUCTIONS (continued)

Keep safety signs clean and legible at all times.

Replace safety signs that are missing or have become illegible.

Replaced parts that displayed a safety sign should also display the current sign.

Safety signs are available from your Distributor or Dealer Parts Department or the factory.

Be sure that the installation area is clean and dry.

Be sure temperature is above 50°F (10°C).

Decide on the exact position before you remove the backing paper.

Remove the smallest portion of the split backing paper.

Align the sign over the specified area and carefully press the small portion with the exposed sticky backing in

place.

Slowly peel back the remaining paper and carefully smooth the remaining portion of the sign in place.

Small air pockets can be pierced with a pin and smoothed out using the piece of sign backing paper.

Failure to follow proper procedures when mounting a tire on a wheel or rim can produce an explosion which

may result in serious injury or death.

Do not attempt to mount a tire unless you have the proper equipment and experience to do the job.

Inflating or servicing tires can be dangerous. Whenever possible, trained personnel should be called to serv-

ice and/or mount tires.

Always order and install tires and wheels with appropriate capacity to meet or exceed the anticipated weight

to be placed on the equipment.

How to Install Safety Signs:

SAFETY SIGNS

TIRE SAFETY

GLB-3000 PARTS LIST

1 2 ... 16 17 18 19 20 21 22 23 24 25

No comments

Worksaver GLB-330 User Manual Page 21