Worksaver GLB-330 User Manual download pdf (Page 19)

718

SAFETY INSTRUCTIONS (continued)

The use of any loader attachment is NOT recommended on tractor with a tricycle wheel arrangement. Tricycle

type tractors are unstable for front loader use.

A heavy load can cause instability in driving a tractor. Make sure the front or rear of the tractor is properly

counter-balanced with weights. Always drive slowly – especially around turns. An unstable tractor could steer

badly and possibly tip over, causing injury or death.

Operate only in daylight or good artificial light.

Always check to be sure the loader attachment is properly latched on the loader or that lock pins are installed.

Never permit any person other than the operator to ride or board the tractor or implement at any time. ALLOW

NO RIDERS!

Ensure that all safety shielding and safety signs are properly installed and in good condition.

Personal protection equipment including hard hat, safety glasses, safety shoes, and gloves are recommended

during assembly, installation, operation, adjustment, maintaining, repairing, removal, or moving the implement.

Do not allow long hair, loose fitting clothing or jewelry to be around moving parts.

Operate the loader attachment only with a tractor equipped with an approved Roll-Over Protective System

(ROPS). Always wear your seat belt on tractors equipped with a ROPS. Serious injury or even death could

result from falling off the tractor – particularly during a turnover when the operator could be pinned under the

ROPS or the tractor. Keep foldable ROPS systems in “locked up” position at all times.

PROLONGED EXPOSURE TO LOUD NOISE MAY CAUSE PERMANENT HEARING LOSS!

Tractors with or without equipment attached can often be noisy enough to cause permanent, partial hearing

loss. We recommend that you wear hearing protection on a full-time basis if the noise in the Operator’s posi-

tion exceeds 80db. Noise over 85db on a long-term basis can cause severe hearing loss. Noise over 90db

adjacent to the Operator over a long-term basis may cause permanent, total hearing loss. NOTE: Hearing loss

from loud noise (from tractors, chain saws, radios, and other such sources close to the ear) is cumulative over

a lifetime without hope of natural recovery.

PREPARA

TION (contin

ued)

OPERATIONAL SAFETY

The use of this equipment is subject to certain hazards which cannot be protected against by mechanical

means or product design. All operators of this equipment must read and understand this entire manual, pay-

ing particular attention to safety and operating instructions, prior to using. If there is something in this manu-

al you do not understand, ask your supervisor, or your dealer, to explain it to you.

OWNER SERVICE

Check the pins at the ends of the loader arms. Make

sure they are locked in place.

Periodically check all bolts to make sure they are tight.

Check the bolt on the forged spears to make sure it is

tight.

Lubricate loader as per instructions in loader manual.

Replace safety signs and instruction decals if damaged

or missing.

Replace any worn or damaged parts immediately. Do

not use attachment with any damaged parts.

WARNING!

Always stop the tractor, set brake, shut off engine,

remove key, and lower loader to ground before

attempting to service. Never leave equipment unat-

tended with engine running.

WARNING!

Do not work under a raised loader unless it is

securely blocked or held in position. Do not depend

on the hydraulic system to hold loader and attach-

ment in place.

REPLACE SAFETY SIGNS

IF DAMAGED OR MISSING.

MAINTENANCE

——————————————————

STORAGE

——————————————————

• Never store equipment with fuel in the tank inside a

building where fumes may reach an open flame or

spark. Allow engine to cool before storing in an

enclosure.

• Do not run engine indoors – exhaust gasses contain

carbon monoxide, and odorless and deadly poison.

• At the end of the working season or when the attach-

ment will not be used for a long period, it is good

practice to clean off any dirt or grease that may have

accumulated.

• Inspect the attachment for loose, damaged or worn

parts and adjust or replace if needed.

• Sand areas where paint is chipped or worn and repaint

to prevent rust.

• Storage location should be level and solid to make

hitching and unhitching easy.

• Always store in a clean, dry location away from chil-

dren and livestock.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25

Comments to this Manuals

No comments

Worksaver GLB-330 User Manual Page 19

Comments to this Manuals